Closure Device Uses Single Suture, Steel Ring

 

April 26, 2010
Quick-Close Suture Applier

A vascular closure device using a single suture fitted with stainless steel rings helps quickly close femoral artery access sites and allows faster patient mobility than compression.

The Quick-Close Vascular Suturing System from Interventional Therapies LLC 
is used to stop the bleeding of a puncture site following an interventional procedure using the femoral artery. It consists of the Quick-Close Suture Applier and the Quick-Ti Cinch Applier. The suture applier has a pistol grip shape and contains a single strand of an artificial suture (polybutester Novafil) fitted with stainless steel rings. The clinch applier has a syringe-type shape with an extended handle.

The suture applier is used to gain access to the puncture site. Using manual control, and relying on the sense of touch, the device is used to place one end of the suture through one edge of the arterial wound. The suture applier is then repositioned and the other end of the suture is inserted through the opposite edge of the wound site. As the suture applier is withdrawn from the wound, a 24-inch length of suture is forced out of its housing. The suture applier places a single stitch of a nonabsorbable, single thread suture to the wound site. The cinch applier gathers the two ends of the suture and then it places a stainless steel ring that acts in place of a knot to secure the suture in a closed position to stop the bleeding.

It is designed for use in vascular punctures with diameters of 4 mm or larger.

The device was cleared by the FDA in April 2010.

The content of this field is kept private and will not be shown publicly.
By submitting this form, you accept the Mollom privacy policy.